We studied solar pumped fiber lasers without primary concentrator. A model of solar sidepumped Nd3+ doped silica fiber lasers was developed using photon tracing method. Theabsorbed power distribution, possible losses and the pumping efficiency are estimated using the model. We analyzed the estimated paramters and drawed conclutions which have many suggests for improved design of solar pumped fiber lasers. The absorption efficiency of a fiber solar laser without a primary concentrator or sun tracker was calculated to be 0.2% for a 190 m fiber. The output power of the fiber laser is 40 mW, and the conversion efficiency from sunlight to laser light is calculated to be 0.06%. The developed model allows one to estimate the overall efficiency, output power and absorption distribution of Nd3+ fiber lasers without focusing optics, enabling various investigative comparisons.
| Mualliflar | Kakhkhorov, A.G., Sherniyozov, A.A., Payziyev, Sh.D. |
|---|---|
| Jurnal | O‘zbekiston fizika jurnali |
| Nashr sanasi | 2023-06-25 |
| Jild | 25 |
| Son | 2 |
| Til | Ingliz |
| DOI | 10.52304/.v25i2.431 |
DOI: 10.52304/.v25i2.431 · Maqolaning asl sahifasi
Daytime heat losses and coolant temperatures at the outlet of flat-plate solar collectors (SC) are studied taking into account the variability of the density of incident solar radiation on the SC. The studies were…
The electrical conductivity of C-4 grade graphite irradiated by fast neutrons with a fluence of 2.22×1019 n/cm2in the temperature range of 298–448 K has been studied. A nonlinear dependence of the electrical…
In the present work, the absorption spectra of all defects characteristic of hydrogenated amorphous silicon are theoretically studied. It has been found that the main role in determining the defect absorption spectrum…
Sb2Se3 films were obtained by chemical molecular beam deposition (CMBE) at a substrate temperature of 400℃. The X-ray patterns show diffraction peaks belonging to the orthorhombic phase of Sb2Se3. The obtained X-ray…
As we know if por-Si/с-Si is deposited on a -type crystalline silicon substrate, the deep levels and surface states are formed in por-Si. Due to the formation of these levels and states in por-Si, the shift of the Fermi…
It has been determined that ZnO1-хSх nanoislands with an average height of about 30−50 nm and densities of 2.9×1011 cm−2 are formed on the surface of ZnO1-хSх films during the deposition of metal oxide layers. It is…
In this work, we studied the change in the elemental and chemical composition of the Cu surface during cleaning by heating in combination with ion bombardment. For the elemental analysis of copper and the chemical…
By implantation of Al+and In+ions and subsequent annealing on the GaP surface, thin singlecrystal GaAlP and GaInP films were obtained. For the first time using the methods of Auger electron spectroscopy, ultraviolet…
In this paper, we study the question whether it is possible to explain the origin of all observed types of bulges of spiral galaxies on the basis of the mechanism of gravitational instabilities of vertical disturbance…
The physico-chemical and mechanical properties of ceramics and composites, which in many respects are superior to modern alloys, are not widely used due to processing difficulties. They can be treated qualitatively by…