Abstract. In this article, we will discuss the identification and mechanism of the application of microorganisms to fertilizers in soil processing. This will help to provide microbiological fertilizer research processes and provide new prospects for the development of new agents, especially microorganisms in the production of microbiological fertilizers in economic agriculture. The research conducted by us was carried out on 3 types of local raw materials: Cattle manure, Poultry manure, Freshwater sludge in the ratio of 100: (35): (50) and selected microorganisms Bacillus sp, Rhizobium sp, Azotobacter sp. in the ratio of 1; 1; 2 for 35 days. As a result, the amount of GK, FK and OM in the fertilizer mixture was 2.08-4.4%, 4.10-4.53% and 30.01-41.8%, respectively, after 35 days. The change in the chemical composition during the composting process was studied.
| Mualliflar | Voqqosov, Zuxriddin |
|---|---|
| Jurnal | Наманган муҳандисликтехнология институти илмийтехника журнали |
| Nashr sanasi | 2025-03-31 |
| Jild | 10 |
| Son | 1 |
| Betlar | 148-152 |
| Til | Ingliz |
| DOI | 10.61151/stjniet.v10i1.745 |
DOI: 10.61151/stjniet.v10i1.745 · Maqolaning asl sahifasi
Keywords: microbiological fertilizer, plant growth promoting bacteria, crop growth, soil regeneration
This article examines the static analysis of a split-cylinder shaft and the process of calculating its torsion angle along with its strength. Using static analysis, forces, moments, stresses, and deformations acting on…
All spinning products, from staple fiber to yarn, are uneven in both linear density and texture. The greater the unevenness, the worse the quality of the product. There are various reasons for unevenness. The impact…
Insufficient smoothness of the saw cylinder shaft leads to impermissible misalignments in the gap between the columns, which has a very negative effect on the grinding process. In this case, using the method of…
Corrosion occurs as a result of friction between moving parts of machines, which leads to the destruction of surfaces. As a result, the dimensions of parts change and the deviation from the required technical and…
The article considers the strength of saw blades for conventional and hexagonal shafts. The maximum stress is determined to be 191 MPa and 193 MPa, the maximum displacement is 0.048 mm and 0.026 mm, the maximum…
The crankshaft group (crankshaft, main and connecting rod bearings) is one of the most critical units of a diesel locomotive, which largely determines its service life, as well as reliability, timing, volume and cost of…
The review of scientific research works devoted to the improvement of the linterization process is devoted to the analytical analysis of literary sources and the current state of technology and technology of the…
The article analyzes the modern range of compression materials, highlighting key factors such as the elasticity, deformation, and abrasion resistance properties of the materials. In the process of designing compression…
The increase in the mass of the cotton pieces slows down the movement and the speed of movement. This, in turn, has a positive effect on the ginning process. From the graphs of the distance traveled and the speed, it…
The article discusses the results of a refining technology for processing long-stored sunflower oil. After adding a filtering agent in the amount of 0.1-0.3% to the same oil samples, an increase in the oil filtration…
Наманган муҳандисликтехнология институти илмийтехника журнали — barcha maqolalar