Corrosion occurs as a result of friction between moving parts of machines, which leads to the destruction of surfaces. As a result, the dimensions of parts change and the deviation from the required technical and technological indicators increases. Practice and research studies have shown that friction and excision intervalsare the main cause of frictional and excited intersection failure. Special devices forstudying wear of surfaces in gears and sliding surfaces of machines have been studied.A simple design of a device that studies wear under laboratory conditions is proposed.
| Mualliflar | Dadakhanov, Nurilla |
|---|---|
| Jurnal | Наманган муҳандисликтехнология институти илмийтехника журнали |
| Nashr sanasi | 2025-03-31 |
| Jild | 10 |
| Son | 1 |
| Betlar | 181-188 |
| Til | Ingliz |
| DOI | 10.61151/stjniet.v10i1.743 |
DOI: 10.61151/stjniet.v10i1.743 · Maqolaning asl sahifasi
gear wheel, wear, friction, oil, plastic, steel, cast iron, machinery, machine tool, kinematics, devices, gears
All spinning products, from staple fiber to yarn, are uneven in both linear density and texture. The greater the unevenness, the worse the quality of the product. There are various reasons for unevenness. The impact…
The crankshaft group (crankshaft, main and connecting rod bearings) is one of the most critical units of a diesel locomotive, which largely determines its service life, as well as reliability, timing, volume and cost of…
Abstract. In this article, we will discuss the identification and mechanism of the application of microorganisms to fertilizers in soil processing. This will help to provide microbiological fertilizer research processes…
The article analyzes the modern range of compression materials, highlighting key factors such as the elasticity, deformation, and abrasion resistance properties of the materials. In the process of designing compression…
This article examines the static analysis of a split-cylinder shaft and the process of calculating its torsion angle along with its strength. Using static analysis, forces, moments, stresses, and deformations acting on…
The article discusses the results of a refining technology for processing long-stored sunflower oil. After adding a filtering agent in the amount of 0.1-0.3% to the same oil samples, an increase in the oil filtration…
Insufficient smoothness of the saw cylinder shaft leads to impermissible misalignments in the gap between the columns, which has a very negative effect on the grinding process. In this case, using the method of…
The article presents an analysis of the influence of wheat grain storage in open warehouses on the aging process of bakery products. The purpose of the studyduring the post-harvest ripening period of wheat grainohBread…
The article considers the strength of saw blades for conventional and hexagonal shafts. The maximum stress is determined to be 191 MPa and 193 MPa, the maximum displacement is 0.048 mm and 0.026 mm, the maximum…
This аrticle рrovides informаtion аbout stаrch contаined in corn, its imрortаnce in food рroduction аnd humаn heаlth, аnd its аррlicаtions in other industries. Аdditionаlly, the stаrch comрosition of two different corn…
Наманган муҳандисликтехнология институти илмийтехника журнали — barcha maqolalar