Insufficient smoothness of the saw cylinder shaft leads to impermissible misalignments in the gap between the columns, which has a very negative effect on the grinding process. In this case, using the method of equivalent diameters developed by B.P. Jemochkin, we determine the bending and turning angles of the saw cylinder shaft.
| Mualliflar | Mirzaumidov, Asilbek, Obidov, Avazbek, Abdurasulov, Axrorbek |
|---|---|
| Jurnal | Наманган муҳандисликтехнология институти илмийтехника журнали |
| Nashr sanasi | 2025-03-31 |
| Jild | 10 |
| Son | 1 |
| Betlar | 208-216 |
| Til | Ingliz |
| DOI | 10.61151/stjniet.v10i1.747 |
DOI: 10.61151/stjniet.v10i1.747 · Maqolaning asl sahifasi
shaft, singularity, bending vibrations, saw cylinder, slack, technological slot, saw, colossian
The article considers the strength of saw blades for conventional and hexagonal shafts. The maximum stress is determined to be 191 MPa and 193 MPa, the maximum displacement is 0.048 mm and 0.026 mm, the maximum…
This article examines the static analysis of a split-cylinder shaft and the process of calculating its torsion angle along with its strength. Using static analysis, forces, moments, stresses, and deformations acting on…
The review of scientific research works devoted to the improvement of the linterization process is devoted to the analytical analysis of literary sources and the current state of technology and technology of the…
Abstract. In this article, we will discuss the identification and mechanism of the application of microorganisms to fertilizers in soil processing. This will help to provide microbiological fertilizer research processes…
The increase in the mass of the cotton pieces slows down the movement and the speed of movement. This, in turn, has a positive effect on the ginning process. From the graphs of the distance traveled and the speed, it…
All spinning products, from staple fiber to yarn, are uneven in both linear density and texture. The greater the unevenness, the worse the quality of the product. There are various reasons for unevenness. The impact…
In this article, an improved design of the device for trapping heavy impurities in raw cotton material is recommended. Theoretical studies have been conducted on this design and the results have been obtained. As a…
Corrosion occurs as a result of friction between moving parts of machines, which leads to the destruction of surfaces. As a result, the dimensions of parts change and the deviation from the required technical and…
Increasing production capacity in the cotton primary processing industry by energy-efficient methods and the rapid introduction of automation methods in the cotton industry have increased the demand for better process…
The crankshaft group (crankshaft, main and connecting rod bearings) is one of the most critical units of a diesel locomotive, which largely determines its service life, as well as reliability, timing, volume and cost of…
Наманган муҳандисликтехнология институти илмийтехника журнали — barcha maqolalar