In this article, an improved design of the device for trapping heavy impurities in raw cotton material is recommended. Theoretical studies have been conducted on this design and the results have been obtained. As a result of observing the operation of the crusher, it was established that even at an acceptable angle of deviation of the deflectors and deflectors, a sufficient amount of cotton raw materials will fall into the bunker intended for the impurities based on the turbulence of the air.
| Mualliflar | Obidov, Avazbek, Mirzaakhmedova, Dilnoza, IBROKHIMOV, ILGORBEK |
|---|---|
| Jurnal | Наманган муҳандисликтехнология институти илмийтехника журнали |
| Nashr sanasi | 2025-03-31 |
| Jild | 10 |
| Son | 1 |
| Betlar | 288-293 |
| Til | Ingliz |
| DOI | 10.61151/stjniet.v10i1.751 |
DOI: 10.61151/stjniet.v10i1.751 · Maqolaning asl sahifasi
Cotton raw materials, stone, heavy mixture, stone catcher, pipe, elastic coating, air velocity, pressure, efficiency
Increasing production capacity in the cotton primary processing industry by energy-efficient methods and the rapid introduction of automation methods in the cotton industry have increased the demand for better process…
The increase in the mass of the cotton pieces slows down the movement and the speed of movement. This, in turn, has a positive effect on the ginning process. From the graphs of the distance traveled and the speed, it…
This article presents the results of an experiment conducted to analyze the movement of cotton seeds under the influence of a screw conveyor. It should be noted that an increase in work productivity leads to an increase…
The review of scientific research works devoted to the improvement of the linterization process is devoted to the analytical analysis of literary sources and the current state of technology and technology of the…
This article explores the process of continuously discharging heavy mixtures from the working chamber of a sedimentation device. It examines the designs of the relevant mechanisms and highlights their shortcomings. The…
The article considers the strength of saw blades for conventional and hexagonal shafts. The maximum stress is determined to be 191 MPa and 193 MPa, the maximum displacement is 0.048 mm and 0.026 mm, the maximum…
This article presents information on the physicochemical properties of the selected raw materials based on local materials and the technology for obtaining an organomineral modifier from it. To modify road bitumens and…
Insufficient smoothness of the saw cylinder shaft leads to impermissible misalignments in the gap between the columns, which has a very negative effect on the grinding process. In this case, using the method of…
This article highlights that the modification with varying amounts of organomineral modifier primarily improves parameters that lead to an increased service life of road bitumens, as supported by data obtained from…
This article examines the static analysis of a split-cylinder shaft and the process of calculating its torsion angle along with its strength. Using static analysis, forces, moments, stresses, and deformations acting on…
Наманган муҳандисликтехнология институти илмийтехника журнали — barcha maqolalar