Coal is not only a heat source for clinker burning but also the coal ash after combustion plays a large role in the quality of clinker mixed with hot meals in the kiln. Since the properties of coal vary depending on the coalification and environment in which it was sedimented, the quality of coal supplying to cement plant can change greatly depending on the coal seam even if it is from the same coal mine. Therefore, the coal used in a cement plant should have its properties measured accurately through representative sampling whenever it is supplied to the plant, and it should be possible to ensure stable kiln operation with stable coal quality. Based on the properties of coal used in 'A' plant for more than 10 years, the permissible coal qualities used in cement plants are evaluated. In order to efficiently utilize the calorific value of coal in the kiln process, the lowest possible intrinsic moisture content is preferred to reduce heat loss due to evaporation of the intrinsic moisture of the coal. In particular, it is examined on the AFT (ash fusion temperature) to obtain the stable clinker quality through well mixing and melting between the coal ash remaining after coal combustion and hot meals in the kiln, and correlation equations for predicting AFTs are suggested according to the chemical components (SiO2, Al2O3, Fe2O3, CaO) in coal ash. In addition, the criteria of chlorine concentration in feeding coal into the kiln process is suggested, so as not to cause process instability due to coating formation within the kiln process caused by repeated volatilization and condensation of chlorine and sulfur compounds due to the circulation behavior of volatile matters, and to enable the stable and continuous kiln process operation.
| Mualliflar | Geun-Seong LEE, Farrukh Erkinov, Mastura Kh. ARIPOVA |
|---|---|
| Jurnal | Kimyo va kimyo texnologiyasi |
| Nashr sanasi | 2025-06-27 |
| Jild | 2025 |
| Son | 2 |
| Til | en |
| DOI | 10.70189/1992-9498.1667 |
DOI: 10.70189/1992-9498.1667 · Maqolaning asl sahifasi · PDF
The aim of the study was preparation of nanosized silver particles by electrolysis from silver-containing scrap from electrical engineering production. For this purpose, at the first stage, silver particles with a size…
The aim of the study was to investigate the possibility of using natural bentonite samples obtained from the Qiziltepa district of Navoiy region in drilling operations. Within the scope of the study, the chemical and…
The aim of this work is to synthesize Nd2O3 nanotubes via chemical deposition followed by thermal treatment. Nd(OH)3 nanotubes were synthesized using Nd(NO3)3 as a precursor and NaOH as a precipitant. After thermal…
The aim of this work is the synthesis of iodine N,N-diallylphthalimide and the study of its radical polymerization. In this regard, the synthesis of iodine N,N-diallylphthalimide was carried out in two stages: at the…
The aim of the study is to conduct a comparative analysis of the technological properties of samples of bakery flour obtained from local and imported varieties of wheat grain at enterprises in Uzbekistan. Existing…
Currently, one of the most effective and cost-effective ways to modify the properties of polyethylene is to introduce various fillers of organic or inorganic origin. The purpose of this work was to study the effect of…
The aim of the work is to study a new method of thermochemical synthesis of luminescent powder of lutetium-aluminium garnet activated by cerium ions (Lu3Al5O12:Се3+) using nitric acid salts of lutetium, aluminium and…
Known sources of high-quality raw materials are depleted. To meet the growing demand for porcelain products, natural raw materials from new deposits are being studied. The aim of the study is to develop a composition of…
The aim of the study was to conduct research to determine the possibility of predicting the approximate fatty acid composition of blends based on the iodine number. The fatty acid composition was determined by the…