In article, the solution of problem of the combined use of fuel in operation is considered. It is shown that during the operation of the gasoline automobile engine the requirement to octane number of fuel changes depending on engine operation mode: at increase in rotary speed the required octane number of fuel decreases, and at increase in loading increase in octane number of fuel is necessary. The combined use of low-bracket gasoline with high-octane liquefied gas is given. The condition supporting necessary octane number of fuel on various modes for ensuring without detonation work and optimization of combustion procedure is defined. At all engine operating modes in operation on combined fuel, only a high-octane component should be supplied. To control the change in the ratio of the supplied components of the combined power system, it is necessary and sufficient to use any combination of the following parameters: – vacuum in the intake manifold; – is the engine speed; – is the degree of opening of the throttle valve of the carburetor, or others, which are functionally dependent on the above. As a result, the feasibility of choosing one or another option is determined by the design features of the fuel combination implementation system
| Mualliflar | B Tulaev, H. A. Viarshyna, Jakhongir Mirzaabdullaev, J Khakimov |
|---|---|
| Jurnal | Тошкент давлат техника университети хабарлари |
| Nashr sanasi | 2019-06-11 |
| Betlar | 263-269 |
| Til | en |
| DOI | 10.51346/tstu-01.19.1.-77-0018 |
DOI: 10.51346/tstu-01.19.1.-77-0018 · Maqolaning asl sahifasi
The article presents results for the preparation of salts of sulfated amides based on oleic acid and piperidine. The products were synthesized in several steps: the first step of the reaction of oleic acid with…
The article discusses the results of an experimental study of the primary processing of silkworm cocoons. In the laboratory of the department of Tashkent State Technical University a full-scale test was carried out for…
Algorithms for increasing the roughness of the procedure for assessing the state vector of control objects to the influence of uncertainty factors are given. Expressions are obtained for extended state vectors and…
A systematic analysis of the technological process of glass melting as an object of automatic control and management has been carried out. As an object of automatic control with distributed parameters, the mathematical…
the article describes the history of cement use, its initial appearance, cement composition and its physicochemical structure and properties, types of cement and classifications of cement. Cement production processes…
Non-linear elements are widely used in various automation devices, converting and measuring equipment. They are often presented in the form of diode-resistive circuits. In single-circuit electrical circuits, their…
The article analyzes the operation of the most commonly used dryers for drying sunflowers and other agricultural cereals. Based on the study of drying technology and methods, the advantages and disadvantages of dryers…
The non-contact measurement method development is caused by the need for precise measurement and elimination of an operator’s errors. The purpose of the atticle research is to develop a reliable small scale prototype…
The fundamental scientific problem of the development of the mathematical foundations of engineering for industrial enterprises and the development of mathematical methods of production management, as well as the…
Research of the interaction of rock-cutting tools with rock with various approaches is presented in the article. In contrast to analytical and experimental methods with their limited and costly applicability, it is…
Тошкент давлат техника университети хабарлари — barcha maqolalar