Research of the interaction of rock-cutting tools with rock with various approaches is presented in the article. In contrast to analytical and experimental methods with their limited and costly applicability, it is proposed to use numerical modeling to better represent the mechanics of rock destruction, to visualize the stages of destruction in a short time and in a cheaper way. This article allows to get an idea that using the finite element method can get mathematical modeling of plastic deformation, assess the stress-strain state of the bit and optimize the structural elements and working conditions of the rock cutting tool, analyze the dynamics of fracture forces and others. The dynamic interaction of the drill bit with the rock in case of two cones with different arrangement of buttons on one crown is investigated. In the process of analysis, it was found that the interaction of paired buttons with rocks has a force action on the area of the rock as well as the cone of the industry bit, but in a more intensively fluctuating way, by also saving energy. Advantageously, the arrangement of the buttons in pairs has not only tensile stress in the longitudinal direction, but also in the transverse direction, contributing to a wide coverage of the fracture zone
| Mualliflar | Lazizjon Toshniyozov, J.B. Toshov, Songyong Liu |
|---|---|
| Jurnal | Тошкент давлат техника университети хабарлари |
| Nashr sanasi | 2020-09-30 |
| Jild | 2020 |
| Son | 3 |
| Betlar | 112-121 |
| Til | en |
| DOI | 10.51346/tstu-01.20.3-77-0081 |
DOI: 10.51346/tstu-01.20.3-77-0081 · Maqolaning asl sahifasi
The article analyzes the operation of the most commonly used dryers for drying sunflowers and other agricultural cereals. Based on the study of drying technology and methods, the advantages and disadvantages of dryers…
For increasing accuracy of a measuring device, before carrying out measurement, implementation of graduation, which consists of the establishment of correlation dependence between indications of the measuring device and…
Non-linear elements are widely used in various automation devices, converting and measuring equipment. They are often presented in the form of diode-resistive circuits. In single-circuit electrical circuits, their…
The article discusses the improvement of traction and energy performance main-line locomotives due to more complete use of possibilities of flexible microprocessor control and efficient algorithm that provides reduction…
A systematic analysis of the technological process of glass melting as an object of automatic control and management has been carried out. As an object of automatic control with distributed parameters, the mathematical…
To create static models of actuators, linear or polynomial equations are used. Such models do not provide the necessary accuracy for the entire system, although they give an adequate result in a specific area of the…
Numerical calculation of electronic and atomic structures of complex systems of crystalline and transitional nano- and micro-sizes by using quantum physical methods will make it possible to forecast new properties of…
The article discusses the results of an experimental study of the primary processing of silkworm cocoons. In the laboratory of the department of Tashkent State Technical University a full-scale test was carried out for…
In article, the solution of problem of the combined use of fuel in operation is considered. It is shown that during the operation of the gasoline automobile engine the requirement to octane number of fuel changes…
A unified mathematical model of the power flow in a system containing a reactive component compensator consisting of capacitor banks connected in series to a thyristor control reactor is presented. The application of…
Тошкент давлат техника университети хабарлари — barcha maqolalar