The article analyzes the operation of the most commonly used dryers for drying sunflowers and other agricultural cereals. Based on the study of drying technology and methods, the advantages and disadvantages of dryers have been analyzed, the results of comparisons of their technical indicators have been presented in tabular form. In the form of a diagram, an analysis of foreign and domestic patent data obtained over the past 10 years for the considered drying devices was presented. The choice of the most suitable installation was carried out on the basis of the compiled analytical table. In order to improve the quality, intensity, efficiency of drying and reduce the cost of the process, recommendations have been developed for a new installation that takes into account the disadvantages of the selected dryer.
| Mualliflar | Jalolitdin Mukhitdinov, Elyorbek Safarov |
|---|---|
| Jurnal | Тошкент давлат техника университети хабарлари |
| Nashr sanasi | 2021-06-28 |
| Jild | 2021 |
| Son | 3 |
| Betlar | 05-19 |
| Til | en |
| DOI | 10.51346/tstu-02.21.3-77-0014 |
DOI: 10.51346/tstu-02.21.3-77-0014 · Maqolaning asl sahifasi
Non-linear elements are widely used in various automation devices, converting and measuring equipment. They are often presented in the form of diode-resistive circuits. In single-circuit electrical circuits, their…
Research of the interaction of rock-cutting tools with rock with various approaches is presented in the article. In contrast to analytical and experimental methods with their limited and costly applicability, it is…
A systematic analysis of the technological process of glass melting as an object of automatic control and management has been carried out. As an object of automatic control with distributed parameters, the mathematical…
For increasing accuracy of a measuring device, before carrying out measurement, implementation of graduation, which consists of the establishment of correlation dependence between indications of the measuring device and…
The article discusses the improvement of traction and energy performance main-line locomotives due to more complete use of possibilities of flexible microprocessor control and efficient algorithm that provides reduction…
The article discusses the results of an experimental study of the primary processing of silkworm cocoons. In the laboratory of the department of Tashkent State Technical University a full-scale test was carried out for…
To create static models of actuators, linear or polynomial equations are used. Such models do not provide the necessary accuracy for the entire system, although they give an adequate result in a specific area of the…
In article, the solution of problem of the combined use of fuel in operation is considered. It is shown that during the operation of the gasoline automobile engine the requirement to octane number of fuel changes…
The article presents results for the preparation of salts of sulfated amides based on oleic acid and piperidine. The products were synthesized in several steps: the first step of the reaction of oleic acid with…
Numerical calculation of electronic and atomic structures of complex systems of crystalline and transitional nano- and micro-sizes by using quantum physical methods will make it possible to forecast new properties of…
Тошкент давлат техника университети хабарлари — barcha maqolalar