The paper considered issues of research into a fuzzy control system for the warping process. During the warping process, the reasons that cause defects in the final finished product have been studied, firstly (remove this word) which are thread breakage, thread tangling, the formation of loops on or under the belt, hanging loose threads and similar factors. To study the warping process, its mathematical model is constructed. Kinematic parameters of stationary movement corresponding to the equilibrium mode were determined by solving the nonlinear functional matrix - equation of movement. The process of breakage the warp of the threads under oscillation conditions in a warping machine is considered. The forces and moments that arise due to oscillations, tensions and hanging threads and the influencing effects on the sag have been studied. In the initial mode, the time constant is reduced and additive disturbances are not taken into account; the transient process is not significantly improved by using a fuzzy controller. With an increase in the time constant or when taking into account external disturbances, the presence of a fuzzy controller made it possible to improve the quality of control.
| Mualliflar | To'xtamurod Hayitmurodovich Avezov, Zokhid Ergashboyevich Iskandarov |
|---|---|
| Jurnal | Кимёвий технология. Назорат ва бошқарув |
| Nashr sanasi | 2024-06-29 |
| Jild | 2024 |
| Son | 3 |
| Betlar | 59-65 |
| Til | en |
| DOI | 10.59048/2181-1105.1575 |
DOI: 10.59048/2181-1105.1575 · Maqolaning asl sahifasi
The purpose of scientific research work is remote control of improving the metrological properties of the water flow measuring device. Therefore, the Arduino platform with an additional ESP8266 NodeMcu v3 and…
This article describes two methods for determining water flow in open irrigation systems: “speed - area” and “slope - area”. The authors considered the problem of its modernization using the existing method for…
The article examines the dynamic characteristics of the mechanical circuit of the developed induction vibration transducer. It is found that in the investigated transducers forced oscillations occur with the frequency…
In the article, a systematic approach to the mathematical modeling of the production process of complex multi-stage elastomeric composites was considered, which allows to take into account the stoichiometric…
The requirements of high operational reliability are most fully met by automated monitoring and control systems, the elements of which are magnetoelastic sensors. Such sensors, due to their metrological characteristics…
The use of Industry 4.0 technologies in modern production serves to increase production efficiency. Robots and robotic complexes with innovative intelligent control are widely used in industrial production. However…
In the article, the magnetic chain of a differential type angular displacement transformer converter with a variable active area of a movable ferromagnetic ring is considered as a magnetic chain with distributed…
The task of performing a technological operation in kinematic calculation of industrial robots and determining various kinematic parameters describing the efficiency of robots is solved. Among them, one of the urgent…
Automatic control systems in the oil and gas processing are considered. After extraction of natural gas condensate, management of technological parameters plays an important role in its processing. Among the parameter…
In this article, the process of real-time prediction of the dynamics of fire development in non-stationary and gas-fired areas is carried out by developing a real-time prediction method based on artificial intelligence…