The article examines the dynamic characteristics of the mechanical circuit of the developed induction vibration transducer. It is found that in the investigated transducers forced oscillations occur with the frequency of the input disturbing force, the amplitude of forced oscillations does not depend on the initial conditions and time, and in forced oscillations with damping there is always a shift of the oscillation phase compared to the phase of the input disturbing force. It is shown that the induction vibration transducer reproduces the measured vibrations with small distortions only in a relatively narrow frequency region at frequencies of the input disturbing force much lower than the natural frequency of the mechanical oscillating circuit. Deviations of the amplitude-frequency response from a constant value at zero value of the input disturbing force characterize amplitude distortion. To reduce amplitude distortion at a given frequency of the input disturbing force, it is necessary to increase the natural frequency of the mechanical oscillating circuit of the converter and to choose a quite certain value of the degree of calming.
| Mualliflar | Sulton Fayzullayevich Amirov, Asror Abdunabiyevich Shoimkulov |
|---|---|
| Jurnal | Кимёвий технология. Назорат ва бошқарув |
| Nashr sanasi | 2023-12-30 |
| Jild | 2023 |
| Son | 6 |
| Betlar | 23-32 |
| Til | en |
| DOI | 10.59048/2181-1105.1534 |
DOI: 10.59048/2181-1105.1534 · Maqolaning asl sahifasi · PDF
The purpose of scientific research work is remote control of improving the metrological properties of the water flow measuring device. Therefore, the Arduino platform with an additional ESP8266 NodeMcu v3 and…
The requirements of high operational reliability are most fully met by automated monitoring and control systems, the elements of which are magnetoelastic sensors. Such sensors, due to their metrological characteristics…
The paper considered issues of research into a fuzzy control system for the warping process. During the warping process, the reasons that cause defects in the final finished product have been studied, firstly (remove…
In the article, the magnetic chain of a differential type angular displacement transformer converter with a variable active area of a movable ferromagnetic ring is considered as a magnetic chain with distributed…
Automatic control systems in the oil and gas processing are considered. After extraction of natural gas condensate, management of technological parameters plays an important role in its processing. Among the parameter…
This article describes two methods for determining water flow in open irrigation systems: “speed - area” and “slope - area”. The authors considered the problem of its modernization using the existing method for…
The article explores the impact of electromagnetic interference on the performance of measuring devices used in industrial environments. An experimental analysis of sensor parameters and the influence of electromagnetic…
In the article, a systematic approach to the mathematical modeling of the production process of complex multi-stage elastomeric composites was considered, which allows to take into account the stoichiometric…
This article is devoted to neural network models of adaptive position-trajectory control systems of moving objects. Neural network models of adaptive positional-trajectory control systems of moving objects have been…
The use of Industry 4.0 technologies in modern production serves to increase production efficiency. Robots and robotic complexes with innovative intelligent control are widely used in industrial production. However…