This article describes two methods for determining water flow in open irrigation systems: “speed - area” and “slope - area”. The authors considered the problem of its modernization using the existing method for determining water flow “slope - area” in open irrigation systems. The essence of the issue is the remote transfer of parameters necessary for calculating water flow in open irrigation systems and improving the means of their processing. In scientific studies conducted by the authors, the required hydraulic parameters were studied using the “slope - area” and “speed - area” water flow methods. Based on experimentally obtained data, the relative error in determining water flow was calculated. The maximum error in measuring water flow using the “slope-area” method compared to the “speed - area” method was 0.7%. The result of scientific research has shown that the “slope-area” method is important for improving the means of water flow.
| Mualliflar | Р. М. Алиев, Djalilov Anvar |
|---|---|
| Jurnal | Кимёвий технология. Назорат ва бошқарув |
| Nashr sanasi | 2024-04-30 |
| Jild | 2024 |
| Son | 2 |
| Betlar | 39-46 |
| Til | en |
| DOI | 10.59048/2181-1105.1566 |
DOI: 10.59048/2181-1105.1566 · Maqolaning asl sahifasi
The paper considered issues of research into a fuzzy control system for the warping process. During the warping process, the reasons that cause defects in the final finished product have been studied, firstly (remove…
In the article, a systematic approach to the mathematical modeling of the production process of complex multi-stage elastomeric composites was considered, which allows to take into account the stoichiometric…
The purpose of scientific research work is remote control of improving the metrological properties of the water flow measuring device. Therefore, the Arduino platform with an additional ESP8266 NodeMcu v3 and…
The use of Industry 4.0 technologies in modern production serves to increase production efficiency. Robots and robotic complexes with innovative intelligent control are widely used in industrial production. However…
The article examines the dynamic characteristics of the mechanical circuit of the developed induction vibration transducer. It is found that in the investigated transducers forced oscillations occur with the frequency…
The task of performing a technological operation in kinematic calculation of industrial robots and determining various kinematic parameters describing the efficiency of robots is solved. Among them, one of the urgent…
The requirements of high operational reliability are most fully met by automated monitoring and control systems, the elements of which are magnetoelastic sensors. Such sensors, due to their metrological characteristics…
In this article, the process of real-time prediction of the dynamics of fire development in non-stationary and gas-fired areas is carried out by developing a real-time prediction method based on artificial intelligence…
In the article, the magnetic chain of a differential type angular displacement transformer converter with a variable active area of a movable ferromagnetic ring is considered as a magnetic chain with distributed…
This article analyzes emergency situations arising from natural disasters (fires, explosions, earthquakes, floods, landslides, etc.) and man-made accidents. The event in which the values of fire risks in the area…