In the article, the magnetic chain of a differential type angular displacement transformer converter with a variable active area of a movable ferromagnetic ring is considered as a magnetic chain with distributed parameters in which the thickness of the movable ferromagnetic ring is a linear function of the angular displacement of the converter. It is shown that although in magnetic chains with a special distribution structure of the magnetic parameters of the resistance of ferromagnetic rings and the magnetic conductivity of the working gap between the rings, the same conditions are created for the passage of the lines of force of the working magnetic field along the steel throughout the entire length of the air gap, due to the distributed nature of the magnetic parameters, there is a non-linearity of the distribution of the working magnetic flux and, consequently, the nonlinearity of the static characteristics of the converter, and the degree of their nonlinearity, the greater, the greater the magnitude of the attenuation coefficient of the magnetic field in the magnetic chain. It is shown that due to the thickness of both rings decreasing from their points connected to the jumper to the diametrically opposite point of the ring according to a linear law, working magnetic fluxes distributed along the angle of these rings strictly according to a linear law are created in the rings, as a result of which the linearity of the static characteristics of the proposed angular displacement converter is achieved.
| Mualliflar | Sulton Faizullayevich Amirov, Ulugbek Shukhratovich Mamadaliyev, Absaid Sulliev |
|---|---|
| Jurnal | Кимёвий технология. Назорат ва бошқарув |
| Nashr sanasi | 2023-10-31 |
| Jild | 2023 |
| Son | 5 |
| Betlar | 22-31 |
| Til | en |
| DOI | 10.59048/2181-1105.1503 |
DOI: 10.59048/2181-1105.1503 · Maqolaning asl sahifasi · PDF
Automatic control systems in the oil and gas processing are considered. After extraction of natural gas condensate, management of technological parameters plays an important role in its processing. Among the parameter…
The requirements of high operational reliability are most fully met by automated monitoring and control systems, the elements of which are magnetoelastic sensors. Such sensors, due to their metrological characteristics…
The article explores the impact of electromagnetic interference on the performance of measuring devices used in industrial environments. An experimental analysis of sensor parameters and the influence of electromagnetic…
The article examines the dynamic characteristics of the mechanical circuit of the developed induction vibration transducer. It is found that in the investigated transducers forced oscillations occur with the frequency…
This article is devoted to neural network models of adaptive position-trajectory control systems of moving objects. Neural network models of adaptive positional-trajectory control systems of moving objects have been…
The purpose of scientific research work is remote control of improving the metrological properties of the water flow measuring device. Therefore, the Arduino platform with an additional ESP8266 NodeMcu v3 and…
This article is devoted to the principles and models of building linear motion actuators with holonomic structure for the movement of intelligent robots. Also, the classification of the elements of the linear movement…
The paper considered issues of research into a fuzzy control system for the warping process. During the warping process, the reasons that cause defects in the final finished product have been studied, firstly (remove…
The paper considers the issues of synthesizing an adaptive fuzzy synergetic controller with discrete time for nonstationary nonlinear dynamic objects. The proposed approach is based on the integrated use of synergetic…
This article describes two methods for determining water flow in open irrigation systems: “speed - area” and “slope - area”. The authors considered the problem of its modernization using the existing method for…