The article presents the results of an analysis of the appearance of burrs on the teeth of a saw cutting machine, the value of which is in The article presents the results of an analysis of the appearance of burrs on the teeth of a saw cutting machine, the value of which is influenced by the gap between the punch (cutting knife) and the matrix, ways of removing it or reducing its geometric dimensions, it is recommended to maintain the value of the gap between the punch and the matrix and use recommendations for cold cutting technology sheet metal stamping, which corresponds to 0.03...0.06 mm for cutting saw blades. fluenced by the gap between the punch (cutting knife) and the matrix, ways of removing it or reducing its geometric dimensions, it is recommended to maintain the value of the gap between the punch and the matrix and use recommendations for cold cutting technology sheet metal stamping, which corresponds to 0.03...0.06 mm for cutting saw blades.
| Mualliflar | Oripov, Jasurbek |
|---|---|
| Jurnal | Наманган муҳандисликтехнология институти илмийтехника журнали |
| Nashr sanasi | 2023-09-30 |
| Jild | 8 |
| Son | 3 |
| Betlar | 135-142 |
| Til | Ingliz |
punch, matrix, burr, tooth, machine, cutting, saw blade, sand bath, gap, size.
Objective. It is a study of the influence of the use of various fuels on engine performance and the performance properties of oils. Methods. During the research, the laws of lubrication theory, methods of planning…
Abstract: Objective: to identify problems and give recommendations on the processes of cleaning cotton at the cotton gins of the region, taking into account the increase in demand and the need for the use of cotton…
One of the major challenges faced when designing garments in garment dyeing is the significant shrinkage of cotton fabric in both length and width during the dyeing process. In previous researches, shrinkage values of…
Objective. Taking into account the large number of cotton fibers grown in Uzbekistan, producing quality products from local raw materials is an urgent task. The goal of the article is to produce a cotton fiber fabric…
The article discusses the design of the saw cylinder of the genie DP-130 family. Ways to improve performance have been studied. A shaft with a hexagonal cross-section was considered as an energy- and resource-saving…
The article proposes mechanisms for reducing credit risks, taking into account insurance instruments, and develops proposals for improving financial literacy and financial inclusiveness of banking services. It also…
To describe mathematical models that calculate geo-technological indicators necessary for the management of physical-chemical hydrodynamic processes. Analyzing methods for solving these models and developing analytical…
This article analyzes the external factors affecting the financial security of construction materials industry enterprises and reveals the specific features of the construction industry in ensuring financial security at…
Cleaning the fiber from impurities in textile enterprises consists in increasing the cleaning efficiency of the fiber due to the installation of a special pipe in the front part of the cleaning machine.
Abstract: The article states about the reorganization of the new system of public administration in independent Uzbekistan, the gradual improvement of the activities of the legislative, executive and judicial…
Наманган муҳандисликтехнология институти илмийтехника журнали — barcha maqolalar