Recycling of techno genic waste accumulated in recent years in Uzbekistan is currently a pressing problem. In this regard, this paper examines the issue of studying the process of enrichment of man-made waste in a cyclone with a fluidized bed. To conduct the experiment on experimental advanced devices with extended zones five types of samples of techno genic waste with the limits of 0.072÷0.078mm, 0.064÷0.070mm, 0.057÷0.063mm, 0.046÷0.055mm and 0.041÷0.044mm have been prepared. Nomograms have been obtained using mathematical models to determine particle size limits, which ensure good separation. Experiments have been carried out on the separation of techno genic waste in three structures of a cyclone with a fluidized bed: cylindrical, cylindrical with one extended zone and cylindrical with two extended zones. The best results are obtained in a fluidized bed machine with one extended zone. The following results were obtained for a sample with a 0.041÷0.044 mm limit size: the number of Mo increased 40 times, Ag increased 20 times, Mn increased 2.5 times, Cu increased 1 time, Ti increased 6.6 times, Ni decreased 125 times and the number of Si in the selected sample decreased from 20% to 12%.
| Mualliflar | Nodirbek Yusupbekov, B. Kh. Yunusov, Sh.B. Gulyamov, I Yunusov, F Kasimov |
|---|---|
| Jurnal | Тошкент давлат техника университети хабарлари |
| Nashr sanasi | 2020-09-30 |
| Jild | 2020 |
| Son | 3 |
| Betlar | 130-140 |
| Til | en |
| DOI | 10.51346/tstu-01.20.3-77-0077 |
DOI: 10.51346/tstu-01.20.3-77-0077 · Maqolaning asl sahifasi
In order to improve the economic performance of the company, the establishment of rational water use schemes and the reduction of the use of fresh water obtained from water supply systems or natural bodies of water can…
The article discusses the modeling of a fuzzy-logical system of regulation of the process of drying of raw cotton. The tasks of overcoming uncertainties arising in the process of operation of technological units at the…
The pulse-frequency control systems are widely used in radar, space industry, for control of technological processes and robots and many other areas. Today, there are various approximate and accurate methods for the…
Both raw and recycled fiber materials are used for paper production. The increase in percentage use of the latter is due to their paper-forming properties, availability and low cost. The article explores the possibility…
It provides information on the method of system thinking, where the analysis of the crusher for grinding solid materials shows four hierarchical structure of the object - the jaw crusher. For a particle - a piece of…
The article discusses the results of studying the material composition and the development of technology for processing gold-bearing sulfide ore samples. The material composition of the ore samples was studied by…
The article considers the influencing technological factors of mining operations on the state of the quarry sides. In technological processes, the stability of the sides of rock and semi-rock rocks and the value of the…
The article discusses the necessity to form internal blades in deep steep falling deposits. The experience of formation and the scheme of blading of internal blades in open-cast mines with different mining and…
The article presents the results of a study to reduce greenhouse gases through the introduction of green technologies. Different countries are making rather tough decisions to reduce greenhouse gas emissions. The basics…
This article shows the wear and the amount of load that occurs in the gears under different loads and under different operating conditions of the contact surfaces, and is given by the formulas. The values of loads and…
Тошкент давлат техника университети хабарлари — barcha maqolalar