The aim of this research work is production of colored antibacterial glaze coatings for ceramic products containing iron (III) and manganese (IV) oxides. The coatings are produced on the basis of multicalcium aluminoborosilicate frit, dolomite and iron or manganese oxides. The constant components in the raw mixture were feldspar, alumina, coal clay and kaolin. The coatings were obtained by finely grinding the components then applied to the dried semi-finished product and single fired at a temperature of 1200±5 °C for 60±2 minutes. The formation of the glaze layer, the decorative properties of coatings, and their physical and chemical and operational properties were examined. The structural features and phase composition of coatings have been studied. Antibacterial activity of coatings against Escherichia coli ATCC 8739 and Staphylococcus aureus ATCC 6538 test strains was determined.
| Mualliflar | I. A. Levitskiy, M. V. Dyadenko, Е. Е. Трусова |
|---|---|
| Jurnal | Kimyo va kimyo texnologiyasi |
| Nashr sanasi | 2024-09-27 |
| Jild | 2024 |
| Son | 3 |
| Til | en |
| DOI | 10.70189/1992-9498.1631 |
DOI: 10.70189/1992-9498.1631 · Maqolaning asl sahifasi
The aim of the study is to develop quality ground enamels based on local raw materials to replace imported ones. Glasses were synthesized in the SiO2–Al2O3–Na2O–K2O–СaO–B2O3–NiO system. The physical and technical…
The goal is to reduce the sintering temperature of ceramics based on zinc orthostannate. This can be done by introducing sintering additives, which are manganese and nickel oxides. During the synthesis of zinc…
The aim of the study is determination of chemical composition, physicochemical and biological properties of the Aral Sea water for further selection of the most economical and environmentally friendly method of lithium…
The aim of the work is to study the physical and chemical foundations of the simultaneous production of sodium hydroxide - caustic soda and burkeite by the conversion of soda ash with calcium hydroxide - milk of lime in…
The purpose of the study is synthesis and reaction ability of sodium percarbonate obtained by the wet method. The sodium percarbonate obtained on the basis of soda ash produced by JV LLC "Kungradskiy soda zavod". The…
A dry extract of the leaves of stevia, belonging to the Asteraceae family, grown in Uzbekistan, was extracted with hot water for use as a sweet flavor additive in the food industry. The content of the extract was…
The aim of the study is to obtain polymolecular complexes based on chitosan and Bombyx mori protein. To obtain complexes, protein and chitin are isolated from silk production waste, from which chitosan is synthesized…
One of the ways to increase the efficiency of the activation process of baking yeast is the use of waste and by-products of the food industry as nutrient media. The goal of the study was to develop ways to activate…
The goal was to study the structure of glass ionomer cements (GIC) developed on the basis of glasses of the SiO2-Al2O3-CaO-ZnO-P2O5-CaF2 system. Glass powders with sizes less than 50 μm were sealed with a 40% solution…
The purpose of this work is to investigate the sorption of Cu2+, Co2+, Ni2+, UO22+ ions, etc. depending on the ionic form of the cationite and the pH of the medium on phosphoric acid cationite obtained by forsforylation…