Annotation. The article describes the technological process of primary processing of cotton, which is accompanied by a significant release of dust from technological and transporting machines into production premises and the atmosphere. The norm of air dust content in the production premises of a cotton gin plant is no more than 10 mg/m3. To create normal sanitary and hygienic conditions, production premises and individual dust-emitting installations are dedusted. Before exhaust dust-laden air is released into the atmosphere, it is also cleaned of dust. At the beginning of the technological process, during transportation and cleaning of raw cotton from impurities, mineral dust is mainly released from it and pollutes the air; at the end of the technological process, especially during linting and compaction, dust of organic origin is released. Despite the installation of the necessary dust removal equipment, many problems and unresolved issues remain.
| Mualliflar | Otamirzayev, Abdulkhadi |
|---|---|
| Jurnal | Наманган муҳандисликтехнология институти илмийтехника журнали |
| Nashr sanasi | 2024-03-30 |
| Jild | 9 |
| Son | 1 |
| Betlar | 45-49 |
| Til | Ingliz |
| DOI | 10.61151/stjniet.v9i1.394 |
DOI: 10.61151/stjniet.v9i1.394 · Maqolaning asl sahifasi
Raw cotton, dust removal, equipment, cyclone, workshop, atmosphere, air, rate, dust, fraction, cleaning, dust suction, percentage, result
Abstract. The article presents a modernized regulator of shuttle thread tension in sewing machines. The scheme of the new effective constructive scheme and the principle of operation of the shuttle thread tension…
Abstract: It was determined that the change in the speed and temperature of the air supplied to drying significantly affects the change in the cleaning efficiency of the cotton cleaning equipment. Cotton with an initial…
Annotation: This article identifies the types of impurities in cotton and their composition. Technologies at cotton ginning enterprises have been studied. Impurity compounds cause a decrease in the quality…
Annotation. Strictly following the specific procedures for each operation is crucial to producing top-quality soybeans. Achieving this quality necessitates on-farm quality control during post-harvest processing. To…
Abstract: Cotton fiber is the most valuable for the textile industry within natural fibers. The products made from it are far superior to other textiles in their ecological purity, high absorbing water. The high quality…
Annotation: To ensure flow and continuity of the juice production process, industry uses continuous presses. In addition, the quality of the juices produced depends, first of all, on the quality and chemical composition…
The advantage of optical information transmission devices is shown, since optical radiation does not create interference and spreads in limited spaces, providing the necessary secrecy of information transmission. The…
In this study, the energy characteristics of water vapor adsorption in NaA and NaA(NaBO2) zeolites were measured by adsorption calorimetry. Information of differential heats, isotherms, entropy and kinetic of…
In the article in order to improve fiber cleaning equipment, it is proposed to improve the elastic mass of fiber on the surface of the saw cylinder in the equipment using an additional device. The scientific work on the…
You can increase the control token (Ib) given to the control churn and reduce the working churn voltage (Uin) and increase the load voltage (U). The variable token bridge is corrected in a semiconductor fixer with a…
Наманган муҳандисликтехнология институти илмийтехника журнали — barcha maqolalar