Abstract. Recently, one of the modern directions of the theory of control, the theory of construction of state monitors of linear and nonlinear dynamic systems has significantly developed [2, 4, 10, 15]. The approach based on the expansion of the system dynamics based on the information of the input and output values due to the construction of a special dynamic system observer whose state converges quickly enough to the initial state of the system over time and the function of the state observer on the output, and the input of the initial system output variables and dynamic feedback can be applied spread out. In this case, the state observer at an arbitrary instant of time is considered as an estimate of the state of the system at a given instant of time [4]. Constructing an observer for a dynamic system is one of the ways to obtain an estimate of the state vector of this dynamic system. Solving such a problem can be of independent value as part of the general problem of dynamic systems control. The article considers the independence of the output value and the error signal from the input actions. In stabilization systems, it is necessary to add independence of the output value from the disturbing influence. The system is invariant with respect to the perturbing influence, if after the completion of the transient process determined by the initial conditions, the system error does not depend on this influence [12-16].
| Mualliflar | Куралов, Бекжон |
|---|---|
| Jurnal | Наманган муҳандисликтехнология институти илмийтехника журнали |
| Nashr sanasi | 2023-09-30 |
| Jild | 8 |
| Son | 3 |
| Betlar | 175-183 |
| Til | Ingliz |
Today, the application of water-oil emulsions will help not only increase the quality indicators of the product but also reduce its cost. This is done by introducing quality products into their composition. But it is…
The article presents the results obtained from ultraviolet irradiation of sunflower seeds in order to obtain higher yields from sunflower, among other agrotechnical measures, to improve the quality indicators of seeds…
Abstract: Objective. The article examines the effect of various components and the addition of chemical reagents (depressant additives) to improve the flowability of paraffin oils. The introduction of the additive…
Purpose: the purpose of the research is to improve the quality of the beret based on the analysis of women's headdresses, to make effective use of natural and seasonal fabrics.Methods: in this article, the history of…
Abstract: Objective. In this article, drawing the basic pattern and method of calculating the shrinkage values for selected cotton fabric to design of a men's shirt produced by the garment dyeing way has been…
Objective. The purpose of this work is to study the method of synthesizing an oligomer containing urethane groups without the isocyanate method, as well as to conduct an infrared spectroscopic analysis to determine the…
Abstract. Objective. In this paper, we conducted research based on a new experimental approach to describe the airflow in a rotor-spinning machine experimentally. This article studied the movement of fibers in the air…
Objective. improve energy efficiency by adjusting the frequency of well pumping equipment. Methods. Frequency adjustment, thermal image management, analytical analysis, energy-efficient operating modes of pumps…
Abstract. Objective. In this article, the movement of fibers in the air channel and the rotor in the pneumomechanical spinning machine was studied. In the experimental work, the uniformity and stability of the velocity…
Summary The experimental results of determining the oil viscosity by controlling the vibration parameters in the operational state of the oil power…
Наманган муҳандисликтехнология институти илмийтехника журнали — barcha maqolalar